Card Type	Fax, Modem (synchronous/asynchronous), Network Interface Card
Chip Set	Unidentified
I/O Options	Ethernet 10Base2 connector, Ethernet 10BaseT connector
NIC Type	Ethernet
Network Transfer Rate	10Mbps
Maximum Modem Rate	14.4Kbps
Maximum Fax Rate	14.4Kbps
Data Bus	PCMCIA Type II
Fax Class	Class I & II
Data Modulation Protocol	Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis
Fax Modulation Protocol	ITU-T V.17, V.21CH2, V.27ter, V.29
Error Correction/Compression	MNP5, MNP10, V.42, V.42bis
Topology	Linear Bus, Star
Wiring Type	Unshielded twisted pair RG-58A/U 50ohm coaxial
Boot ROM	Not available

CONNECTIONS
Function	Label		Function		Label
10BASE-2 - RG-58A/U 50ohm coaxial		CN1		10BASE-T - Unshielded twisted pair		CN2

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED 1	Yellow	On	Link integrity good on 10BASE-T connection
LED 1	Yellow	Off	Link integrity broken on 10BASE-T connection
LED 2	Green	Blinking	Sending or receiving data
LED 2	Green	Off	Not sending or receiving data

SUPPORTED COMMAND SET

Basic AT Commands

AT, ‘Comma’, A/

A, B, C, D, E, H, L, M, N, O, P, Q, S, T, V, W, X, Y, Z

&C, &D, &F, &G, &J, &K, &L, &M, &P, &Q, &R, &S, &T

&V, &W, &X, &Y, &Z

Extended AT Commands

\A, \B, \G, \K, \L, \N, %C, %E, %l, %Q, %TT

S Registers

S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S16, S18, S25, S26, S29, S30

S32, S33, S37, S38, S39, S46, S48, S82, S86, S91, S92, S95, S99, S201

Special Commands

)M, *H, -K, -Q, @M, :E, #CID

Note: See MHI Help file for full command documentation.