M P A - 3 0 1 7 A T FUJITSU Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 8713| 3390| | Capacity form/unform 1750/ MB Heads 2| 16| | Seek time / track 11.0/ 3.0 ms Sector/track | 63| | Controller IDE / ATA3 Precompensation Cache/Buffer 128 KB Landing Zone Data transfer rate 10.000 MB/S int Bytes/Sector 512 16.700 MB/S ext PIO4 Recording method PRML 8/9 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 60 Power: sleep W Humidity % 8 80 | 5 85 standby W Altitude km -0.060 3.000| -0.060 12.000 idle 3.5 W Shock g 10 | 75 seek W Rotation RPM 5400 read/write 4.0 W Acoustic dBA 35 spin-up W ECC Bit SMART MTBF h 500000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** FUJITSU MPA-30XXAT JUMPER SETTING +---------------------------------------+-------+--------+ |* * * * * * * * * * * * * * * * * * * *| * * * |X X X X | |* * * * * * * * * * * * * * * * * * *| * * * | | +----IDE-Interface----------------------+-CN1---+-Power--+ ********************************************************************** J U M P E R S ********************************************************************** FUJITSU MPA-30XX AT JUMPER SETTING Jumper Setting ============== +---------------------------------------+-------+--------+ |* * * * * * * * * * * * * * * * * * * *| * * * |X X X X | |* * * * * * * * * * * * * * * * * * *| * * * | | +----IDE-Interface----------------------+-CN1---+-Power--+ ---------+-------+--------+ * * * * *| xxx X |X X X X | Master Drive Setting (default) * * * *| * * X | | --------+-CN1---+-Power--+ ---------+-------+--------+ * * * * *| xxx * |X X X X | Slave Drive Setting * * * *| * * xx| | --------+-CN1---+-Power--+ ---------+-------+--------+ * * * * *| xxx * |X X X X | Cable Select Mode (CSEL) * * * *| * xxx | | --------+-CN1---+-Power--+ Alternate Jumper Settings for Partitions Larger than 2.1 GB =========================================================== On initial boot, the system BIOs may lock up on drives that have more than 4098 cylinders (driver larger than 2.1 GB). Alternate jumper setting have been provided for drives that are larger than 2.1GB to overcome this system BIOS limitation. These jumper settings cause the drive to report 4092 cylinders (instead of the usual 4960,6296 or 7752) in Word 1 of the Identify Drive data. ---------+-------+--------+ * * * * *| X * X |X X X X | Master Drive Setting (default) * * * *| X * X | | --------+-CN1---+-Power--+ ---------+-------+--------+ * * * * *| X * xx|X X X X | Slave Drive * * * *| X * * | | --------+-CN1---+-Power--+ ---------+-------+--------+ * * * * *| X * * |X X X X | Cables Select (CSEL) * * * *| X xxx | | --------+-CN1---+-Power--+