CONNECTIONS
Function	Location
40-pin AT Interface (IDE) connector	CN1
34-pin control cable connector-floppy drive	CN2
15-pin game port	CN3
9-pin serial port 2 - internal	CN4
9-pin serial port 1 - internal*	CN5
9-pin serial port 1 - external*	CN6
25-pin parallel port-external	CN7
4-pin connector-drive active LED	CN11
Note:* These ports share the same I/O port addresses and may not be used at the same time.

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Configuration Register set by hardware (jumpers)	JP1/jumper 1	pins 2 & 3 closed
	Configuration Register set by software	JP1/jumper 1	pins 1 & 2 closed
»	Floppy drive enabled	JP1/jumper 4	pins 2 & 3 closed
	Floppy drive disabled	JP1/jumper 4	pins 1 & 2 closed
»	Factory configured - do not alter	JP1/jumper 5	pins 1 & 2 closed
»	Two Floppy drives supported	JP1/jumper 5	pins 2 & 3 closed
»	Hard drive enabled	JP9 and JP10	closed
	Hard drive disabled	JP9 and JP10	open

SERIAL PORT CONFIGURATION
CN4	CN5/6	JP1/jumper 6	JP1/jumper 7	JP1/jumper 8
COM2	COM1	pins 2 & 3	pins 2 & 3	pins 2 & 3
Disabled	COM1	pins 2 & 3	pins 2 & 3	pins 1 & 2
COM1	COM2	pins 2 & 3	pins 1 & 2	pins 2 & 3
COM1	Disabled	pins 1 & 2	pins 1 & 2	pins 2 & 3
COM2	Disabled	pins 1 & 2	pins 2 & 3	pins 2 & 3
Disabled	COM2	pins 2 & 3	pins 1 & 2	pins 1 & 2
Disabled	Disabled	pins 1 & 2	N/A	pins 1 & 2
Note:Pins designated should be in the closed position.

PARALLEL PORT (CN7) CONFIGURATION
LPT		JP1/jumper 2	JP1/jumper 3
»	LPT2 (378-37Ah)	pins 2 & 3 closed	pins 2 & 3 closed
	LPT3 (278-27Ah)	pins 1 & 2 closed	pins 2 & 3 closed
	LPT1 (3BC-3BEh)	pins 2 & 3 closed	pins 1 & 2 closed
	Disabled	pins 1 & 2 closed	pins 1 & 2 closed