WESTERN DIGITAL CORPORATION
WD1002S-WX2
|
Data bus: 8-bit, PC/XT
Size: Full-length, half-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: None
CONNECTIONS | |
Function |
Location |
34-pin control cable connector-hard drive |
J1 |
20-pin data cable connector-drive 0 |
J2 |
20-pin data cable connector-drive 1 |
J3 |
USER CONFIGURABLE SETTINGS | |||
Function |
Location |
Setting | |
Reserved for BIOS |
SW1/8 |
open | |
Reserved for BIOS |
SW1/7 |
open | |
Reserved for BIOS Virtual option |
SW1/6 |
open | |
Reserved for BIOS Auto-config option |
SW1/5 |
open | |
» |
Normal operation |
W1 |
pins 1 & 2 closed |
Factory test |
W1 |
pins 2 & 3 closed | |
» |
Normal operation |
W2 |
pins 1 & 2 closed |
Factory test |
W2 |
pins 2 & 3 closed | |
» |
BIOS enabled |
W3 |
closed |
BIOS disabled |
W3 |
open | |
» |
I/O port address 320h |
W4 |
pins 2 & 3 closed |
I/O port address 324h |
W4 |
pins 1 & 2 closed | |
» |
BIOS size 32K or 64K (hard-wired) |
W5 |
pins 1 & 2 closed |
BIOS size 16K |
W5 |
pins 2 & 3 closed | |
» |
8 Head hard drive with RWC supported |
W6 |
pins 2 & 3 closed |
16 head hard drive supported (Head Select 3) |
W6 |
pins 1 & 2 closed | |
» |
Hard Drive Interrupt is IRQ5 (hard-wired) |
W7 |
pins 1 & 2 closed |
Hard Drive Interrupt is IRQ2 |
W7 |
pins 2 & 3 closed |
BIOS DRIVE TYPE TABLE - SW1 JUMPERS 1 AND 2 CONFIGURE DRIVE 1 JUMPERS 3 AND 4 CONFIGURE DRIVE 0 | |||||||
# |
Jumper 1 & 3 |
Jumper 2 & 4 |
Cap. |
Hds. |
Cyls. |
WP |
RWC |
0 |
closed |
closed |
21MB |
4 |
612 |
613 |
613 |
1 |
open |
closed |
10MB |
2 |
612 |
128 |
128 |
2 |
closed |
open |
21MB |
4 |
612 |
128 |
613 |
3 |
open |
open |
10MB |
4 |
306 |
all (0) |
306 |
MISCELLANEOUS TECHNICAL NOTES |
This controller has a built-in low-level format program. To enter the program run the DEBUG utility supplied with DOS and at the prompt enter: G=C800:5. |