Card Type	Hard drive controller card
Hard Drives supported	Four EIDE drives
Floppy drives supported	None
Data Bus	32-bit PCI
Card Size	Half-length, full-height card

CONNECTIONS
Function	Location	Function	Location
40-pin primary IDE(AT) connector	J1	2-pin connector - drive(IDE2)active LED	J4
2-pin connector - drive(IDE1) active LED	J2	Paddle card connector	W1
40-pin secondary IDE(AT) connector	J3

USER CONFIGURABLE SETTINGS
Function		Label	Position
»	Disk change enabled	W2/A	Closed
	Disk change disabled	W2/A	Open
»	Factory configured - do not alter	W2/C	Open
»	Factory configured - do not alter	W6	Pins 2 & 3 closed
»	Factory configured - do not alter	W7	Pins 2 & 3 closed

LEGACY/NATIVE MODE SELECTION
Mode	W2/B	W5	W6	W7
IDE1 & IDE2 Legacy	Closed	Open	Pins 2 & 3 closed	Pins 2 & 3 closed
IDE1 Legacy IDE2 Native	Open	Closed	Pins 2 & 3 closed	Open
IDE1 Native IDE2 Legacy	Open	Closed	Open	Pins 2 & 3 closed
IDE1 & IDE2 Native	Open	Closed	Open	Open

PRIMARY IDE INTERRUPT SELECTION
Interrupt	W3/A	W3/B	W3/C	W3/D
INT A	Open	Open	Open	Closed
INT B	Open	Open	Closed	Open
INT C	Open	Closed	Open	Open
INT D	Closed	Open	Open	Open

SECONDARY IDE INTERRUPT SELECTION
Interrupt	W4/A	W4/B	W4/C	W4/D
INT A	Open	Open	Open	Closed
INT B	Open	Open	Closed	Open
INT C	Open	Closed	Open	Open
INT D	Closed	Open	Open	Open

MISCELLANEOUS TECHNICAL NOTES

Older motherboards that do not have the capability to route IRQ24 and IRQ15 to the PCI slots, require you to use the separate paddle card to transfer those signals to the PCI bus. The paddle card is inserted in an ISA slot and connected to W1 on the controller board with a 10-pin cable.