D P L A - 2 4 4 8 0 T R A V E . 5 G S IBM Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders | 9264| | Capacity form/unform 4480/ MB Heads | 15| | Seek time / track 12.0/ 4.0 ms Sector/track | 63| | Controller IDE / ATA3 Precompensation Cache/Buffer 96 KB Landing Zone Data transfer rate 9.000 MB/S int Bytes/Sector 512 16.600 MB/S ext Recording method operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | 65 Power: sleep 0.1 W Humidity % 8 90 | 5 95 standby 0.3 W Altitude km -0.300 3.000| -0.300 12.000 idle 1.3 W Shock g 100 | 400 seek W Rotation RPM 4900 read/write 2.5 W Acoustic dBA spin-up 5.0 W ECC Bit MTBF h Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** IBM DPLA TRAVELSTAR 5GS JUMPER SETTING +--------------------------------------+ | | | | | | +--------Interface-------------49------+ | **********************1 **47 Jumper | *************x********* **48 | +------44----------------------50------+ + + Pin position 20 is left blank for secure connector insertion. ********************************************************************** J U M P E R S ********************************************************************** IBM DPLA-24480/25120 TRAVELSTAR 5GS JUMPER SETTING Jumper Setting ============== Drive Address Setting --------------------- A jumper is available at the interface connector to determine the drive address. Using Cable Selection, the drive address depends on the condition of pin 28 of the AT interface cable. In the case when pin 28 is ground or low, the drive is a Master. If pin 28 is open or high level, the drive is a Slave. ---49--47+ * * * | Master * * * | (Default setting) ---50--48+ ---49--47+ * * X | Slave * * X | ---50--48+ ---49--47+ * * * | Cable Selection * xxx | ---50--48+ ---49--47+ * xxx | RESERVED (MASTER) * * * | ---50--48+ ---49--47+ * X * | NEVER ATTACH A JUMPER HERE! * X * | ---50--48+ ********************************************************************** I N S T A L L ********************************************************************** -ANY DIREC. Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+ The drive will operate in all axis (6 directions).